As time moves on, technology gets...well, more technical. In the good old days when you wanted to shift the gears in your truck all you had to do was push in the clutch, pull a lever, and let out the clutch. But eventually that seemed too difficult so someone invented the automatic transmission filled with fluid, clutches, bands, valves, pumps, and planetary gearsets all designed to shift gears more smoothly and quicker than a manual. And then when that seemed too simple they added a computer to help it work even better. Don't get us wrong, automatics are great when they are working right, but they can also be a giant headache when they act up, especially when you're buried in the mud miles from home.
For example, we've been working on a '91 3/4-ton Chevy truck that we've christened the Red Sled (it turns like a toboggan) with the goal of testing some hard-core Independent Front Suspension (IFS) components. We got this truck for a song because it was missing an engine, but it's been an uphill project from the start. To make a long story short, we stuffed an engine in, lifted the truck, upgraded the steering, and took it wheeling. Then the electronic automatic transmission died, so we rebuilt the tranny and it died again. At this point we were really considering installing a manual transmission, but we already had that swap in motion for another project, so we decided to explore the options of keeping the auto, but making it better.
Since this truck is a work, camping, and wheeling truck it needs a reliable gearbox, a way to keep track of and control the heat the tranny is making (heat kills automatics), and better low-range gearing to help move this 7,000+ pound behemoth off road. The Sled came from the factory with a 4L80E automatic and an NV241 transfer case. The 4L80 is similar in strength to the venerable TH400 but with the added benefit of an overdrive Fourth gear-both great aspects-but it is also computer controlled, which 99 percent of the time isn't a problem. However, it can create additional dilemmas when changing tire size and gearing, or if you wanted to swap this transmission into another vehicle. To get the most of our 4L80 we headed to Off Road Unlimited where we pulled the 4L80E out and then took it to B&M Racing for a rebuild and an external controller, which would allow us to have greater control and diagnostic management of the trans.
Since the NV241 only has a 2.72:1 low range we decided an upgrade had to be made in the transfer-case arena. Our choice was a STAK three-speed Monster Box transfer case, which replaced our strong chaindrive 241 with massive geardriven internals, both a 3.05:1 and 5.44:1 low range, and the ability to run low range from either front or rear output individually. What we ended up with is a greater range of gearing off road, and a more user-friendly transmission management system on road. Plus the ability to get our Red Sled back on the trail, and once there, really test the strengths of an independent front suspension. Stay tuned to find out what happens when big-block power, super-low gearing, extremely obese curb weight, and big tires are applied to an independent front suspension in the rocks.
-
The first step of any tranny swap is to remove the driveshafts, transfer case, and transmi
-
With the electronic 4L80E automatic out, we hauled it over to B&M to be gone through, beef
-
Unlike other automatics, these electronically controlled units have solenoids and wired co
-
B&M installed a shift improver kit to give the truck more positive, solid shifts. The kit
-
One problem we were having with the trans was a leaking pan. We ditched the aftermarket co
-
One of the biggest threats to automatic transmissions is heat. To help the factory cooler
-
When rebuilding your transmission it is required that you either rebuild or replace your t
-
We took the rebuilt 4L80E over to Race Trans, a small shop known for its truck and diesel
-
One problem we had with the transmission prior to the rebuild was keeping track of what ge